La-crosse-technology WS-9118U Manual do Utilizador

WS-9118U Wireless 433 MHz Radio-controlled Weather Station Instruction Manual

10weather is not largely affected by the change of air pressure, the sensitivity setting should be set to 1. In areas where the air pressure changes

115. While “MIN” is still displayed press and release the IN/HR button again to return to the current data display. While in the record display mo

12V. MOON PHASE There are 12 moon phases shown on the indoor weather station. Thus, when the moon icon is all white, it is a full moon. New

13B. VIEWING AND OPERATING WITH MULTIPLE REMOTE TEMPERATURE/HUMIDITY SENSOR UNITS 1. To view the temperature, humidity, heat index and dew point of

141) Pull the stand out from the bottom center edge of the weather station, below the battery compartment. 2) Once the foldout table stand is exte

15SPECIFICATIONS Weather data measuring range: Indoor Temperature: 14.1°F to 139.8°F with 0.2°F resolution “OFL” displayed if outside this range Outd

16WARRANTY INFORMATION La Crosse Technology, Ltd provides a 1-year limited warranty on this product against manufacturing defects in materials and w

2TABLE OF CONTENTS Topic Page Inventory of Contents/Additional Equipment 3 About WWVB 3 Quick Set-Up Guide 4 Detailed Set-Up Guide Battery install

3Moon Phase and Date LCD INVENTORY OF CONTENTS 1. The WS-9118U weather station (Figure 1). 2. One TX7U remote temperature/humidity sensor (Figur

4QUICK SET-UP GUIDE Hint: Use good quality Alkaline Batteries and avoid rechargeable batteries. 1. Have the indoor weather station and remote temper

5DETAILED SET-UP GUIDE BATTERY INSTALLATION A. REMOTE TEMPERATURE/HUMIDITY SENSOR 1. Remove the battery cover by sliding the cover dow

6PROGRAM MODE Programming Note: If 15 seconds are allowed to pass, or the SNOOZE/CH button is pressed during the programming mode, the unit will con

7Note: It is possible to select any time zone from –12 GMT to +12 GMT (for example to see the time in another country) TIME ZONES GMT 0 Atlantic

8VIII. TIME SETTING There are two methods by which the time and date can be set: A) Automatically via WWVB reception, or B) Manually. A. WWVB (R

9Note: The snooze can be set for 0 to 30 minutes in 5-minute increments. If 0 minutes is selected pressing the WIND/SNZ button will deactivate the